American-car-craft Corvette Floor Mats - Diamond Plate 2Pc Black Show User Manual download pdf

AMERICAN CAR CRAFT INSTRUCTIONS

Part#041004

DIAMOND PLATE FLOOR MATS

INSTALLATION NORMALLY REQUIRES NO TOOLS

1. Slide front seats as far back as they go.

2. Your custom diamond plate mats come to you flat and it will be necessary to form

By hand to achieve a perfect fit. Your mats are made of high quality aluminum

and will bend very easily. Some mats will have marks on the back that will

indicate where you must bend the mat and whether that the bend should be a hard

bend or a soft bend. You can use the edge of a table to create the hard bend. The

soft bend can be achieved by hand. It may be necessary to place and bend 2 or

more times until you are satisfied with the fit. Some floor mats will be pre-formed

by the factory.

3. Once you are satisfied with the fit remove the carpet attachment tape covering and

insert the mat into position. NOTE: Be sure that the mat creates no restriction of

the gas, clutch or brake pedals. Repeat this same process for all remaining mats.

Most all rear mats require no bending and should fit just right.

AMERICAN CAR CRAFT INSTRUCTIONS Part#041004 DIAMOND PLATE FLOOR MATS INSTA

No comments

American-car-craft Corvette Floor Mats - Diamond Plate 2Pc Black Show User Manual