American-car-craft Corvette Plenum Cover Low Profile Polished 1997-20 User Manual

Browse online or download User Manual for For the car American-car-craft Corvette Plenum Cover Low Profile Polished 1997-20. American Car Craft Corvette Plenum Cover Low Profile Polished 1997-2004 C5 & Z06 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
AMERICAN CAR CRAFT INSTRUCTIONS
C5 POLISHED LOW PROFILE PLENUM COVER
PART# 033029
PARTS INCLUDED:
1x Low Profile Plenum Cover
2x Strips of Velcro Attachment Tape
1x Pack of Adhesive Promoter
1x 2pc Decorative Chrome Valve Covers
1x Test Kit
Introduction:
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in
place until the installation is complete to prevent finger prints and or possible scratches during installation.
1. Surface Preparation: Your new cover is designed to attach to your existing stock fuel rail covers via
Velcro tape. PLEASE NOTE: If silicone treatments have previously been applied to your fuel rail
covers please refer to the special preparation instructions attached. If silicone treatments have not
been applied then continue by first removing all road dirt and grime with soap and water. Then
scrub your fuel rail covers along the entire most inner corner with household isopropyl alcohol.
(This is where your new plenum cover will sit). Let dry then wipe same area with the adhesive
promoter (provided).
2. You have been provided with two decorative plastic chrome vacuumed valve covers specifically
designed to cover the large vacuumed valve just to the driver side of the factory plenum. Dab a
small amount of common household 100% silicone (clear) to the valve, set the half cut cover onto
Page view 0
1 2

Summary of Contents

Page 1 - PART# 033029

AMERICAN CAR CRAFT INSTRUCTIONS C5 POLISHED LOW PROFILE PLENUM COVER PART# 033029 PARTS INCLUDED: 1x Low Profile Plenum Cover 2x Strips of Velcro Att

Page 2

the valve and then install the round bezel over the remaining end to completely cover the valve. This will nicely trim the valve in chrome, see pictur

Comments to this Manuals

No comments