AMERICAN CAR CRAFT INSTRUCTIONS
2000-2001 VIPER Rear Bake Caliper Covers 2Pc - Polished
Part # 962034
PART INCLUDED:
1-Right Side Caliper Cover with Viper Head Logo
1-Left Side Caliper Cover with Viper Head Logo
1-Tube Adhesive Promoter
1. Jack up your viper and set on jack stands for safety then remove one front wheel and one rear
wheel.
2. Before you take the protective liner off each part - Hold a caliper cover up to each wheels caliper to
make sure it fits properly on your Viper. Now that you know that each cover will fit your car you can remove
the remaining wheels from your Viper.
3. Thoroughly scrub clean all four calipers. It is crucial that this step be done completely thoroughly to
insure a good reliable bond. Apply some common masking tape to all the areas to see if you have achieved a
tack able surface. If the masking tape sticks then swipe the area of the calipers to be mounted with the
adhesive promoter provided.
This chemical is key to establish a good reliable bond long term. This chemical is not a cleaner but an
adhesive accelerator and must be used as such to insure a permanent bond
Comments to this Manuals