American-car-craft HHR Fog Light Kit Polished 2006-2012 User Manual download pdf

AMERICAN CAR CRAFT INSTRUCTIONS

HHR STAINLESS FOG LIGHT TRIM

PART#422017

PARTS INCLUDED:

___2-Brushed or Polished Stainless Fog Light Inserts

___2-1/4 Strips Chrome Molding

___1-Adhesive Promoter Pack

___1-Adhesive Promoter Tube

Your new bezel inserts have been designed to fit nicely into the fog light opening. The

shape and contour match the physical surface area HOWEVER it will be necessary to

manually tweak the overall fit in order to achieve a nice contoured gapless installation.

Because these inserts are constructed of a thin gauge stainless, shaping them will be very

easy.

1. Thoroughly clean the opening with alcohol to remove any wax, road grime and dirt.

Then swipe the entire area to be mounted once with the adhesive promoter packet

provided.

2. Place the insert into the opening. You will notice that the bezel will need to be shaped

in certain areas in order to conform to the basic shape of the opening. The stainless insert

is very thin and will conform to you adjustments. This will take a little time to get them

just right so BE patient. You will notice that the factory fog lights have a plastic frame

surrounding the light and that the new bezels will fit in between the surround and the

opening. When fitting the inserts start by placing them into this small gap. This will

expose just where the inserts will need to be adjusted. Make these adjustments by hand a

little at a time until you have achieved the shape of the opening with out forcing the insert

to conform. A properly shaped insert will look installed (before the liner is removed)

when placed in position after adjustments have been completed. It is important to know

that the process of shaping the bezels in this way will insure that the inserts will stay in

position and also that they will not pop out of shape long term. So the more time you

invest into the shaping of the part the better the installation will be.

3. Once you have achieved a nice contoured fit you can now begin to permanently install

the part by peeling the red release liner from the attachment tape on the back of the

inserts. Smear a little rubbing alcohol directly to the attachment tape. (Doing this will

1 2

PART#422017 1
727-861-1500 2

Summary of Contents

Page 1 - PART#422017

AMERICAN CAR CRAFT INSTRUCTIONS HHR STAINLESS FOG LIGHT TRIM PART#422017 PARTS INCLUDED: ___2-Brushed or Polished Stainless Fog Light Inserts ___2-

Page 2 - 727-861-1500

temporarily remove the aggressive tack of the attachment tape and allow you to place the bezels in position). Allow the alcohol to evaporate after a f

Comments to this Manuals

No comments

American-car-craft HHR Fog Light Kit Polished 2006-2012 User Manual

Browse online or download User Manual for For the car American-car-craft HHR Fog Light Kit Polished 2006-2012. American Car Craft HHR Fog Light Kit Polished 2006-2012 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car American-car-craft HHR Fog Light Kit Polished 2006-2012