AMERICAN CAR CRAFT INSTRUCTIONS
HHR STAINLESS 3PC UPPER HOOD CAP
PART#423002
PARTS INCLUDED:
___3-Stainless Plates
___1-Adhesive Promoter Packet
Your new inserts come to you with a clear protective liner. Do not remove this liner until
installation is complete.
Your new inserts have been designed to fit into the upper hood catch as well as the two
key hole shaped recesses to offer a nicely finished upper hood area.
1. Remove the two center redundant hood stops. NOTE: These will not be
reused. Prepare the three areas first by scrubbing with rubbing alcohol
to remove any road grime and dirt then swipe the areas once with the
adhesive promoter provided.
2. You will notice that the two smaller keyhole shaped inserts have an
attachment tape applied to the back of the part. This tape is not
sufficient to permanently install these parts and must be used in unison
Comments to this Manuals