American-car-craft Prowler 3rd Brake Light Trim with Kat Logo Polishe User Manual download pdf

AMERICAN CAR CRAFT INSTRUCTIONS

Prowler High Polished Stainless Steel 3

Brake Light Bezel

PART #822010

PARTS INCLUDED:

1-3

Brake Light Bezel

1-Adhesive Promoter

PROTECTIVE LINER INFORMATION: Your new accessories will come to you with a protective surface liner.

Leave this liner in place until the installation is complete to prevent finger prints and/or possible scratches

during installation.

1. Wash your 3rd Brake light with soap and water. Rinse thoroughly and dry.

2. Take your Bezel out of the wrapper. Do not remove the back red tape covering.

3. Take your Bezel trim and put it up to your 3rd Brake light. Position it as you want to permanently mount

it. You might want to slightly bend the ends in to match the slight bend in your cars lens assembly. You

can do this by trial and error. Once you are comfortable with exactly how it will fit, move to the next step.

4. Take your promoter pen and wipe the perimeter of your 3rd brake light where the trim bezel is going to

attach.

5. You may now take the red backing off the back side of your trim piece. Very carefully position the Trim

Bezel in place without touching it against the 3rd Brake light. Once you are certain that is where you want

it, lightly set it on the 3rd brake light while still holding it. Make any final tiny adjustments. Once this is

done, press on the bezel to secure it against the 3rd brake light. With your fingers - press all the way

around the bezel to ensure it is sticking to the 3rd brake light on all sides.

1 2

AMERICAN CAR CRAFT INSTRUCTIONS Prowler High Polished Stainless Steel 3rd Brake Light Bezel PART #822010 PARTS INCLUDED: 1-3rd Brake Light Bezel 1-A

Page 2

6. You may even want to stick pieces of masking tape over the bezel attaching it tightly to the 3rd brake light housing. Leave it overnight for a tig

No comments

American-car-craft Prowler 3rd Brake Light Trim with Kat Logo Polishe User Manual