AMERICAN CAR CRAFT INSTRUCTIONS
CAMARO ZL1 ENGINE PLENUM COVER
PART #103059
PARTS INCLUDED:
1-Plenum Cover
2- M6 x 25 HEX Flange Head Bolts
Introduction: This new accessory has been designed to fit directly over the top of the factory plenum cover
and is not a replacement.
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in
place until the installation is complete to prevent finger prints and or possible scratches during installation.
1. Remove the strut brace.
2. Remove the factory Red plastic Engine Shroud by pulling it up and from its attachment tabs.
3. Use the Plenum Cover as a guide to locate the (4) side bolts used to attach the Plenum Cover.
4. Set the Plenum Cover aside for now and remove the (4) side bolts and save for re-installing.
Comments to this Manuals